MID49 Power Distribution Box DB-12 (Blackmagic URSA Cine, V-Mount High Voltage)

Overview Power Distribution Box DB-12 (Blackmagic URSA Cine, V-Mount High Voltage) attaches directly to the camera body using five M3 screws and provides intelligent power distribution with D-Taps, 5V USB-C PD, 3pin Fischers, and 2pin LEMO compatible connectors. The included USB-C cable can be installed inside DB-12 and connected to the top-rear port on the camera body to enable remote start/stop capability using 3-pin Fischer devices. Hot-swap between on-board battery and 8pin LEMO compatible connector without losing camera or accessory power. When both sources are connected, the DC INPUT takes priority down to 22.8V at which point, the DB-12 will switch to an onboard battery. With the SMART FUSE design, camera power is monitored, and the remaining power budget is allocated to accessories. For example, the URSA Cine uses approximately 4.8A at 28V, so when using a 10A capable battery, the remaining 5.2A is allocated for accessory use. If an accessory configuration exceeds the 5.2A limit, accessory power is cut off, leaving the camera powered. The “SMART FUSE” LED will illuminate, showing the error, and once the configuration has been adjusted to lower than 5.2A, the RESET button can be pressed, and power will be re-enabled to accessory outputs. In the event of a complete short circuit, the system will immediately shut down and can only be turned back on once the short circuit has been removed. Specifications Compatibility Blackmagic URSA Plate Front / Battery Mount V-Mount Plate Rear Mount V-Mount Battery Plate Number of Battery Bays 1 Accessory Mounting No Indicator No Inputs/Outputs 1x DC Jack (21 to 34 VDC) Input2x D-Tap/P-Tap (15 VDC) Output2x LEMO 3-Pin Output2x LEMO 2-Pin (15 VDC) Output1x USB-C (5 VDC / 3 A) Output Weight 13.6 oz / 386 g